Secret technology, Tesla stan

[Login to see usernames]

Me too haha!!!

[Login to see usernames]

Thanks, Steve.  I know you're the one who keeps the forum going.  And you kept it from being shut down, which would have been the worst thing which could happen to a forum.

That's very true, I'm very thankful all you pecker heads are still here!!!

Thanks, Hydrocars.   It's nice to feel appreciated.  I'll always be around.  But I am going to join the IGTOW movement.  (Inventors Going Their Own Way).  Most of the stuff I'm into is a little too 'alternative' for a specialised forum like this.  And this is my last forum.  I just wanted to do a little public service work, trying to help sort this all out.

[Login to see usernames]

Thanks, Steve.  I know you're the one who keeps the forum going.  And you kept it from being shut down, which would have been the worst thing which could happen to a forum.

That's very true, I'm very thankful all you pecker heads are still here!!!

Thanks, Hydrocars.   It's nice to feel appreciated.  I'll always be around.  But I am going to join the IGTOW movement.  (Inventors Going Their Own Way).  Most of the stuff I'm into is a little too 'alternative' for a specialised forum like this.  And this is my last forum.  I just wanted to do a little public service work, trying to help sort this all out.

Pop by, once in a while when you are bored..
I will continue with the alu and alternative fuelcell idea.
I like it.

good luck!
Steve

[Login to see usernames]

Ok, Hydrocars.

I have made an attempt to replicate what you draw.
I have tried some coils and capacitors and a diode.
Drawing nr. 3
Step number 1 i have on my breadboard.
When i short the AP, i get a spark / bang.
And then i blew up my mosfet.....kak
I used the primary of my ignitioncoil with similar capacitors as you showed.
What is next?

[Login to see usernames]

I'll post schematic tonight.

[Login to see usernames]

Stevie, charge the cell first for step 3. That's a very difficult circuit to tune, when u get close you'll see small bubbles then large ones. Use a coil that's 24 volts. Try to use an air core. That means 20 to 30 ohm coil. Start at 600 hertz be very patient with this circuit.

[Login to see usernames]

120v to 12 volts transformer iron core, TV chokes. Don't laugh don't knock it till you try it. This is the circuit I used to put static potential across the cell. Works with distilled water and additives doesn't consume what u might think! Try her out!

(This is very very low scale)

[Login to see usernames]

Thanks. I have to search for parts and then i will give it a try.
Is it self oscillating?