Image 1 --calipered picture of a significant advance by Tony Woodside
Image 2 --calipered picture of another VIC posted on the net (scale different) relative scaling program not applied
Image 3 --calipered picture of original Meyer VIC (2010 visit)
Image 4 picture of VIC from Stanley Meyer Estate 1 video
The spacers between the coils in the second photo are about 0.10 inches
the red coils are 1.5 inches in direction of wind in the second photo
--------------------------------\
message from dynodon that he posted to me
I have some measurements to give you for the coils.
Using the above pictures as a referance the dementions are as followed.
The length of the large coils(left to right) 1.312 inches.
The width of the coils (top to bottom) 1.5 inches
The height of the coils(table up) 1.16 inches.
Coil base size measures .360 x .675 inches.
Length of small feedback coil (green) is.380 inches.
Wire size was 29 gauge .0115 inches.
My calculations for the primary wire is between 600-650 turns, wire resistance measured 10.5 ohms
Secondary 3000-3200 turns, wire resistance measured between 70-75 ohms between the three coils (2 chokes and secondary)
Now get busy
Don
---------------------------------
thanks to Dynodon for average layer technique in calculation, but I still like the change in shape from ellipse to circle with increasing winds and Steinhaus packing factor approach though.
********
go lcalc
go dim matrix
go dim part
go sub rand wnd
********
3093
********
