A green and clean environment is a human right!
Off Topic => World News and political stuff => Topic started by: outlawstc on September 17, 2010, 04:22:31 am
-
found this on youtube, sent a email to him asking for a description of his set up.. under the video is his reply
My water does not get hot. I think its because i use really thick gauge stranded copper wire(dont use stainless wire cause it has high resistance and this is why it heats up). My alternator has only 3 sets of 2 wires...not sure if that matters. I have no bifilars so far but may add a microwave transformer. I can easily run at .30 and will do a vid of it if i remember on the weekend. I did not rewind mine, just pulled out the regulator and wired up the brushes.
I am not sure how much of a difference derlin would make at this point for me.....but who knows, i might try it one day....busy busy busy. YOurs is absolutley capable as i tried it with one cell, but it looked like a jet engine:)
Again, i didnt rewind the alternator...just used a highvoltage one, and pulled the regulator...
all the best.
thewonn
-
-
how is he measuring the amps?
-
i would have to say this guy has it... 260ma i believe and its piping
-
I think so
-
haithar,
sorry didnt notice your post until now, he didnt say, all i have is the email he sent back to me above i sent him another email asking if he was willing to share more information will let yall know if he replys..
-
He is not doing anything special from what have already been done several times with the alternator here.
-
can you explain your set up yaro?
its performance (efficiency and consumption) and configuration..
-
I do not have that setup. If you do a search you can find similar setups by hydrocar and others.
-
Yes, thewonn does not seem to be very forthcoming with details.
There is no mention of configuration, circuit or anything on the youtube channel.
I have tried a deregulated alternator, and you get 0 production unless he is stepping up voltage or something else more exotic...