A green and clean environment is a human right!
Electrolysis => Fuel Cells => Tube Cells => Topic started by: badnova56 on December 30, 2007, 00:47:00 am
-
It is winter break for me at college and i have been working my tail off to be able to afford materials for a WFC. I was looking around online and wow, that 10 tube cell that stevie put together is a nice piece. I was maybe thinking about going with a bigger diameter plexiglass tube with the same legnth. I saw someone who had sucess with an old ford truck with a "Joe Cell." I am sure you all know what this is, but has anyone had any experience with this type of cell. I was going to try and make multiple "Joe Cell" style multiple tubes with a stanley meyers layout. To clarify Instead of only putting 2 tubes with a 1.5 to 2mm gap, i would put maybe 3 or 4 tubes in a mutiple setup much like stevie which would have a total of 30 to 40 SS tubes. I need to power a V8, so i might need a little more gas than the average 4 cyl. I was also thinking about using some old nitrous oxide solenoids on a carbureted intake manifold to plum the HOH gas into my cylendars. Please give me some feedback.
Thank you
Badnova56
-
i cant disagree on you doing that because i havent seen it done! i will tell you this, my cell i made the way i wanted, i didn't go by what others did nor what their cells looked like. i seen stanleys and i was on my own!
after i got my cell working then i started to find forums. totally up to you how you want to make it. you could end up with the "WORST CELL", or the "BEST CELL". its just a chance that you're taking if you decide to go that route.