so wait from my understanding the choke radius is....approximately 4.5 inches in diameter?

...the photos of dynodon holding it do not look 4.5 inches......

NOW EVERYTHING CALCULATED HERE IS IN INCHES.

anyways with the numbers you have given me....we would have to wind the ss wire for each choke approximately [(N) 496.4 turns]....another thing is how is the length of the coil (B) different for every coil?? they should all be the same....i am going to use the information from the file you emailed me .....the outer which is (2.875)-(.238)-(.415)= 2.222 and the inner which is (2.875)-2(.238)=2.399 and the average of both of those would be [2.3105 (B)]

the depth for the inner would be 1.625-1.250= .375 while the depth of the outer would be 2.750-2= .75 and the average of those would be [(C) .5625]....now this depth is correct if we fill each cavity to the brim and each and every cavity if just plained filled.

the mean radius would be the inner plus the outer.....2/2=1 1.25/2=.625....625+1=1.625......1.625/2= [.8125 (A)]

now another thing is for the N factor...i'm not sure if i would multiply this by two since it is for each inductor or leave it alone......for this i will use it as it is.

so from that we plug it into our equation to yield.

L = 4158.46 microHenries

and now we can calculate the capcitance at our chosen frequency to give us 40,000 volts......because if we were to add a water capacitor with a higher capacitative reactance (Xc) than our VIC's inductive reactance (Xl) this coil would produce jackshit.....

be sure to check out my calculations i have posted under my project section.....so everyone can understand how to calculate there desired frequency for there setup.