New VIC pictures discussion!!!

[Login to see usernames]

This question has already been asked.Yes it appears that this coil was for the TRC (injector),but as I said earlier,I think it replaces all previous models.But it would require a different winding ratio,that we will have to work out for ourself.Just because we have a coil doesn't mean it will work.You still need a pulse circuit to run it.
Don

[Login to see usernames]

does anyone have a source for th EI core? is it 3/4 x 3/4 for the center and 3/4 x 1/2 for the perimeter?

[Login to see usernames]

The EI core would have to be custom made.It's not a off the shelf size.It is 3/4" square and the outside legs will be half the size of the center leg.The standard would be 3/8" wide.I'm talking to a company now to see about getting some made.Plus these laminates are thinner than normal also.
Don

[Login to see usernames]

Food for thought .The E core in the picture looks in close resemblence of the GM HEI ignition coil used in the earlier electronic ignition systems tha are mounted in the distributor caps.

[Login to see usernames]

Not even close in size to a HEI from GM.This coil is twice the size.I'm quite familiar with the HEI junk GM sells.Two different coils.You will have to get them custom made like I already said.Or you can prove me wrong.Good luck with that.
Don

[Login to see usernames]

I know your response to the GM coil, DynoDon.

However...

I just happen to have one and don't own a GM anything.  It was on sale 2 years ago at Advanced Auto - so I figued why not.

Now, do I just put it back in a box and continue storing, or get the grinder?   

Warj1990

[Login to see usernames]

Nice find bro , Looks like the right size.

If its silicon steel good with high freq and thin enough its good ...

[Login to see usernames]

MSD Core:

3 inch by 3 inch outside to outside.
5/8 inch center leg, 5/8 inch depth also.
3/8 inch end legs, 5/8 inch depth also.

Does close count?

I now need to know how important 10 ohms per foot is (to prevent amp flow and make a static transformer).

I have some 43 and 45 awg wire - don't know if that will work right

Still need an old sewing maching to build a coil winder.

Warj1990