Hi,
I did a test yesterday and have been thinking about this strange idea a long time.
I really had no time but i just had to check something out i a hurry..
Made a SS plate cell : 80x80x1 mm with 1,2 mm gap between plates.( all separated and isolated with nylon spacers)
Used my 220 Volt 300w pure sine wave inverter, a 1,5 meter lamp whire with a switch and a diode brigde to cell.
Connected the plates like this : 120VAC / 120VDC (NEGATIVE) / 120VAC / 120VDC (POSITIVE)
The idea was to let the AC current pulse the DC current.. so i get high voltage and low amp
Went outside in cold ice wind to my car in the dark with only a big flashlight.
Cut an 5 liter clear plastic drinking water container in half, put the cell in the container, filled it with ordinary tap water with no additives.
Connected it all to my car, turned the switches on and......
The water (2,5 liter) was smoking white at once and there came lot big bubbles too so i liked it a lot.
But every 4 sec. my inverter starts to beep and light red so i had to turn it off and on in a pulse on 3 sec. so it didnt shut down.
Anyway it was fun..
Possible improvements can be done :
Lower volt or bigger spacing between the plates
Maybe isolate some of the plates on the AC side and put a small load on it before the cell
Add four inductors and test with a blocking diode.
Try this with a quad tube cell
Is this Meyers secret?
If someone believe this is a good idea or usefull somehow please come with your opinion, ideas, improvements about this strange setup..
Best regards
