Another post by a certain Bob Boyce
I personally examined the electronics and system used by Herman Anderson. The US DoE (Dept of Energy) would certainly not allow such a system to be used on a passenger vehicle, especially with Homeland Security around these days, due to the high risk of radioactive tritium generation. He was given a personal exemption due to his expertise, and the fact that he had worked for the governement in the specialized field of ionics.
The Herman Anderson car used a basic 3" length of plastic pipe with 13" round metal plates. Pretty much a drum electrolyser to generate the hydroxy gas, using fairly high current pulsed DC. The timing circuit ran at 15 Hz, with the pulse train run through a flip-flop. The two outputs at 7.5 hz each were fed to alternating loads, one was the switching for the pulsed DC driving the cell itself, and the other was the switching for pulsing the car coils. The output of the car coils was directed to a length of ignition wire that was wrapped like a coil around the perimeter of the cell drum, then terminating into a spark gap to the outside of the electrode plate. His electrodes were plated mild steel in order to obtain his desired magnetic effects while retaining chemical resistance to the base electrolyte.
As Herman was an expert in ionics, his goal was to bump up the energy level of the hydrogen to deuterium as simply as possible. While the simple setup can seem to be misleading to those that do not understand radiolysis. The combined effect of the extreme high voltage, and the spark gap, is to create both very sharp charge gradient impulses, and electromagnetic impulses, to irradiate the electrolyte and gas. So while he speaks of radiation, it is not the sort of radioactivity that one would require the use of heavy shielding for. The EMI produced would pretty much be contained by the metal shielding of a closed hood and crowded engine compartment. As long as the voltage was maintained in the correct range, deuterium production could be maximized while tritium production could be minimized.
Yes, there was a water fog injection system. The use of water fog allows for an additional amount of thermally expansive mass to be inducted into the engine, as the water fog will absorb energy during combustion and flash to steam.
There are a lot of similarities in the method that Herman Anderson used, and in the method that Stanley Meyer used in one of his systems.
Bob Boyce
More of Bob on Anderson
Just a single reference should be enough to get the wheels turning in your mind. I really do feel that you are intelligent enough to take it from there, but can you overcome your natural tendency to just dismiss everything you do not immediately understand as fantasy.
Isotope separation - Wikipedia, the free encyclopedia
Scroll down to "Alternatives":
"The only alternative to isotope separation is to manufacture the required isotope in its pure form. This may be done by irradiation of a suitable target, but care is needed in target selection and other factors to ensure that only the required isotope of the element of interest is produced."
You seem to grasp part of the concept of pumping matter to higher energy states, now all you need to do is make the connection that photons are just another form of EM radiation. And yes, isomeric and isotopic changes to matter CAN be driven via EM irradiation. Sometimes it takes multiple wavelengths at the same time in order to obtain a desired effect. Sometimes phase is not important, sometimes it is, it depends upon the goal.
And more:
If you would refer again to the link I posted, and scroll down to "Alternatives", then you would see that irradiation to create a desired isotope is an ALTERNATIVE to seperation.
Surely you are not so niave as to believe that even distilled water is so pure as to contain no other elements besides the bound hydrogen and oxygen. Or that matter cannot be broken down and reformed via application of energies. If so, then I am likely wasting my time.
Matter is energy. If one can learn how to interfere with the energy matrix of that matter, one can alter that matter. The simplest patterns are the components that make up the smallest components in atoms. Hydrogen is the most abundant element in the universe because the hydrogen atom has the simplest energy matrix of all atoms. Therefore, it is also the easiest atom to alter.
