Stanley Meyer > General Stan Meyer topics

Water Fuel Cell Resonant Cavity dimensions/shape?

(1/3) > >>

HMS-776:
Recently I have been trying to determine the exact size of the Water Fuel Cell Resonant Cavity. The one in which all the tubes are covered with delrin sleeves. So far I know that the inner rods are 4" in length, .5" ID, and the outer tube is .75" ID and 3" in length. But what about the delrin housing itself that held all the rods, and the delrin sleeves which covered each rod?   
 
 
 
 

Dynodon:
The resonant cavity has a 2-1/2 inch hole in the center,and the caps were 1 inch O.D. and 1-1/2 inch long.
The center rod was 4 inches long and the outside tube was 2-3/4 inches long.
That should help.
Don

HMS-776:
Thanks Don,
I thought I read somewhere that the ID of the delrin case was 6", and the height was 9". Just trying to figure out what size it might have been. It seems like most of his components were smaller than they look.
 
So did the outer tube slide into another delrin sleeve to completly cover it?

Dynodon:

--- Quote ---So did the outer tube slide into another delrin sleeve to completly cover it?
--- End quote ---

What do you think the base is made of ?
Don

HMS-776:
I guess that was a dumb question...Just trying
To get an idea on how it was designed.

Navigation

[0] Message Index

[#] Next page