Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »   Go Down

Author Topic: Spikes Cell  (Read 41287 times)

0 Members and 1 Guest are viewing this topic.

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 343
Re: Spikes Cell
« Reply #16 on: March 05, 2008, 22:49:43 pm »
Do you have any pictures of the SS wire connections at the tubes?
Lookin good nice bubbles, nice bubbles.
Logged

Offline Login to see usernames

  • Member
  • **
  • Posts: 267
  • OO-Rah!
Re: Spikes Cell
« Reply #17 on: March 05, 2008, 23:31:24 pm »
No I don't have any pictures of the wire welded to the tubes. But it's 1/8" SS rod. Started on the center tube, then wrapped around the outside tubes, 3/4" up on the tubes.  I ended up tapping the inside tubes for 5/8" bolts to a SS plate. Next time I take it apart, I'll take a picture.

Spike
Logged

Offline Login to see usernames

  • Member
  • **
  • Posts: 267
  • OO-Rah!
Re: Spikes Cell
« Reply #18 on: March 11, 2008, 02:45:54 am »
I keep getting brown junk in the water. It may be chlorine, Because it has a pool smell when i open the cell afterwards. And I also found out the hard way about not having a good heat sink, so here is my new one.

Spike
Logged

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 343
Re: Spikes Cell
« Reply #19 on: March 11, 2008, 02:51:06 am »
Which circuit are you using? 
Logged

Offline Login to see usernames

  • Member
  • **
  • Posts: 267
  • OO-Rah!
Re: Spikes Cell
« Reply #20 on: March 11, 2008, 02:58:32 am »
I was using the old one, when i burned up my mosfet. I'm going to order the parts this week, for the new one.

Spike
Logged

Offline Login to see usernames

  • Member
  • **
  • Posts: 267
  • OO-Rah!
Re: Spikes Cell
« Reply #21 on: March 11, 2008, 03:02:36 am »
got two 30 sec clips on alternator alone.

spike
Logged

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 343
Re: Spikes Cell
« Reply #22 on: March 11, 2008, 03:13:16 am »
Cool stuff Spike!  Whats the HP rating on your driver motor?  How much bigger pulley do you think you will need?
Nice setup. Got anymore vids?
Logged

Offline Login to see usernames

  • Member
  • **
  • Posts: 267
  • OO-Rah!
Re: Spikes Cell
« Reply #23 on: March 11, 2008, 03:37:01 am »
I need to go to a 6" pulley to get the right rpm's. the motor is a 8.7 amp 1/2hp, and that may not be enough.

Spike
Logged
Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »   Go Up