it has been found that a wfc connected to an injector from a 1996 dodge neon can can make water burn.
the hydroxy in the line connected to the injector contained a small amount of water, at first the water was a pure stream but as the water started to run out a fog appeared from the tip of the injector exiting from the 4 small pinholes in the tip of the injector.
a white misty cloud formed containing Hydroxy mixed with water mist. notes where taken on the hydroxy burn spurts from the injector without the use of water, it is clear the invisible mist was explosive but did not appear to burn only pop.
the added water in the hose from the later test showed that when the water was in a pure squirt form from the injector it puts the flame out. however, when the water started to run out the injector started to spit then mist a white hazy cloud into the air. the Cold water mist mixed with hydroxy at the injectors output "will" result in a flammable water mist.
now the question is, how do you get the right water mist mixed with hydroxy? stans car appeared to have a water pump inside his fuel cell on his dune buggy. i am thinking you run the hydroxy threw the bottom of a water tank while rapidly shaking the water into a bubble form, then feed to the injector. the injector will mist when the water is running out, or not pure. this leads me to believe you need bubbly water of some sort that has been mixed with hydroxy some how.
if you know of or find the video where he has a Motor hooked to a shaft which is going into his cell please post that picture.
this is not found on the internet, this is test i have tested.
good day, OH, i really hope you save this information somewhere.
