WFC VIC

[Login to see usernames]

Thanks again Don! Sorry for all the questions... Is the measured 1Kv the target voltage you are shooting for? Why did you choose that value?

[Login to see usernames]

1kv is just what it makes with these coils.I didn't set it up to that value.I will probably wind new coils to get around 2kv.Stan states that around 1kv the water molecule starts to elongate.So I want to be over that mark.
Don

[Login to see usernames]

Don - SM actually states that it will start to elongate at circa 1500V. 

[Login to see usernames]

Just figured I would post this image that I drew up. It's the Pulse Triggering Circuit from the 8XA circuit.
(http://www.globalkast.com/images/stanmeyer/PulseTrigger_Trace.png)

-Tony Woodside-
.: Water Fuel Cell Research :.
http://www.globalkast.com

[Login to see usernames]

Techhbrief mentions for wiregauge 0.002, 0.004 and 0.03, what are these numbers (diameter?) and to which AWG do they correspond?

[Login to see usernames]

-this is in inchs

[Login to see usernames]

Alan your mixing up different coils designs.Those values go to the water injector coils.Alot of people here needs to keep reading the tech brief, to get a better understanding of the different types of tech he actually had.Too many people are mixing up his work.READ THE BRIEFS!!!!It's all in there and get it straight as to what coil goes to what cell.
Don

[Login to see usernames]

I know these are for the injector
These numbers from the techbrief (part 6) I cannot find them on this page:
http://en.wikipedia.org/wiki/American_wire_gauge