WFC VIC

[Login to see usernames]

Here are some images of the 5 coil VIC that I made along with the cores. I just need to order the wire and wrap the coils now. Hopefully I'll have this done by the time I finish up the circuit.

(http://www.globalkast.com/images/tonywoodside/SDC10825.JPG)

(http://www.globalkast.com/images/tonywoodside/SDC10826.JPG)

(http://www.globalkast.com/images/tonywoodside/SDC10827.JPG)

[Login to see usernames]

@Tony
Nice work on the pcb's and VIC bobbins!

I'm very curious how that flat iron powder core is going to preform when pulsed...

I'm searching for iron powder plate/rod material/core, don't want to make one with powder myself.

br,
Webmug

[Login to see usernames]

very nice work tony !
 
are the cores custoum made?
I think that figs.2,3,6,11,12 are all part of the GMS unit(dashboard box)
 
I am trieng to figure out what the A26 chip of the "gated pulse frequency generator" (fig6) might be. Any ideas ?
 
hydrogenmask
 

[Login to see usernames]

Yea I referred to this is an earlier post about the VIC. Look at the excerpt from one his Patent 92007861 below. He's basically saying the Sec. = 10X Primary and the same for the chokes and then he's just combining them and saying 30:1 step-up.
(http://www.globalkast.com/images/stanmeyer/patent_92007861.PNG)

Tony did you noticed that he is talking about secondary to choke ratio and not primary to secondary?

[Login to see usernames]

very nice work tony !
 
are the cores custoum made?
I think that figs.2,3,6,11,12 are all part of the GMS unit(dashboard box)
 
I am trieng to figure out what the A26 chip of the "gated pulse frequency generator" (fig6) might be. Any ideas ?
 
hydrogenmask

Yea the IC for the "Gated Pulse Frequency Generator" is a 74122 =)

[Login to see usernames]

that is fast as a reply!
rettigerable monostable multivibrator

I`m still confused how to connect this thing up!


I will appreciate if you can help me out Tony


HM

[Login to see usernames]

I've edited your schematic and added the pin numbers.

(http://www.globalkast.com/images/stanmeyer/wo92-6.jpg)

[Login to see usernames]

very nice work tony !
 
are the cores custoum made?
I think that figs.2,3,6,11,12 are all part of the GMS unit(dashboard box)
 
I am trieng to figure out what the A26 chip of the "gated pulse frequency generator" (fig6) might be. Any ideas ?
 
hydrogenmask

Yea the IC for the "Gated Pulse Frequency Generator" is a 74122 =)

Have you seen the circuits inside the dashboard GMS unit?

DOnt think the 74122 is correct its most likely a 555
also the schematic is wrong, those "AND" logic pairs should actually be XNORS it was drawn wrong... but in all actuality thesse can be omitted
because theres no real need for them and the capacitor between wont allow them to work

i believe this was some patent misdirection to keep the technology protected