Author Topic: In need of SS  (Read 7160 times)

0 Members and 1 Guest are viewing this topic.

Offline Login to see usernames

  • Moderator
  • 50+
  • *
  • Posts: 68
Re: In need of SS
« Reply #8 on: October 13, 2009, 00:33:18 am »
Its not a free donation , only aa very reasnable bartering and paying the shippping/gas/time/beer ....

I pay for 12 tubes of good lenght and not used often , I will get the 6 others , I need plates also , same caracteristorcs .  I might as well be me that is using them and than tubes laying around .

I will grateful to this person , these words are not to be taken lightly .


Offline Login to see usernames

  • Jr. member
  • *
  • Posts: 25
Re: In need of SS
« Reply #9 on: October 13, 2009, 04:25:15 am »
Take a look at these; 304, 0.040" wall 1/2 and 3/4", the skinny one is longer, 13" I think

18-8 bolt MIGged onto the end, then beaten straight and ground smooth.

 14 pairs

Not precise, not a cobble-job either. [depends on the cobbler]

I'm in OHIO, USA

Turtle

Offline Login to see usernames

  • Jr. member
  • *
  • Posts: 25
Re: In need of SS
« Reply #10 on: October 13, 2009, 04:29:13 am »
What for size plates are you after?

I have some 0.074" thick 10" long, 1.5" wide 316L to spare

Turtle

Offline Login to see usernames

  • Moderator
  • 50+
  • *
  • Posts: 68
Re: In need of SS
« Reply #11 on: October 13, 2009, 06:06:45 am »
Hi Keith

It is a bit short but if the shipping is not so much I will take them. I will be needing either only tubes or plates .

But I will remember your generosity either way ... Thx you