Thank you for the welcome Steve,
nice avatar you have there.
Quiet to the point actually.
(Says: "Mean People Suck")
After I wrote that and wandered a way to do other things.
A simple test occurred to me for someone to try.
Take some medium wire, like a coat hanger or so.
Make a loop that leaves about a quarter inch / half a centimeter
of space all the way around the chamber, and solder it.
Leave the remaining wire as a handle...
If even a small amount of that reading is true,
then this test for induction heating should work.
with the loop slid off the chamber bring it up to temp,
then slide the loop over the chamber keeping the space.
The induction effect should make it bright red near instantly.
A test that only needs a coat hanger, and a few minutes to make.
