Stanley Meyer > Electron Extraction

Electron Extraction circuit

(1/3) > >>

CarbedNotch:
(http://i.ytimg.com/vi/5W1bQkvvU3E/2.jpg)

Steve:
very unclear video, CN

An EEC must be setup like this:
1 set of 2 tubes for creating Hydroxy
On top of them with more then 0,5 inch space another set of 2 tubes.
If you use 1 tube for eec, then you  need the ground of the producing tubes and you will not extract electron for the water, but from your input circuit.
So, the EEC must be a floating circuit!

br
Steve

CarbedNotch:

--- Quote from: stevie1001 on May 22, 2008, 08:53:01 am ---An EEC must be setup like this:
1 set of 2 tubes for creating Hydroxy
On top of them with more then 0,5 inch space another set of 2 tubes.
If you use 1 tube for eec, then you  need the ground of the producing tubes and you will not extract electron for the water, but from your input circuit.
So, the EEC must be a floating circuit!

br
Steve

--- End quote ---

Thanks Stevie!
I did notice I had to share the ground...

CarbedNotch:
Heres a new update vid:
(http://i.ytimg.com/vi/hABBWO71zOo/2.jpg)

CarbedNotch:

--- Quote from: h2opower on May 22, 2008, 23:06:38 pm ---A SS screen mesh will do the trick also.

--- End quote ---

How would you go on about hooking that up?

Navigation

[0] Message Index

[#] Next page

Go to full version