6watts and 8 liters HHO per minute...........

[Login to see usernames]

Ok, this one was still on my to do list.
Here a picture of my testcell showing gas.
A note: it is charged, only by bemf.
I use the primary of an ignitioncoil.

[Login to see usernames]

Hello Steve.
Nice to see you're still working on it.
I am also working on my cell, but in a different prespective.

Cheers

[Login to see usernames]

If i find some time tomorrow, i will build the EEC part.
I think a P channel switch should be able to do that.
When the coil is charged, i also have to discharge the cell with the EEC circuit...however it will look like.
When the coil is discharging it self into the cell, the eec must be switched off.
It will be interesting to see if removing the charge of the cell, trully boost gas production...

[Login to see usernames]

well, i had the eec running.
A lightbulb was burning.
No special results to mention on that.

So i played a bit futher...
And then this happend..

[Login to see usernames]

what you done there?

i kind of see this happening in the past but it was a cable that were not well contact with the electrode in my case..

[Login to see usernames]

i simply squerewaved the cell.
The signal frequency is 3 hz.
The change in amps is way slower going up and down....
So wierd...

[Login to see usernames]

what you done there?

i kind of see this happening in the past but it was a cable that were not well contact with the electrode in my case..

Sometimes you connect info .......
watch from 39:10
Puharich pulsed slow ...2 a 3 seconds per pulse
To flip protons.

Its very intresting

[Login to see usernames]

Dedicated to Nikola Tesla

All we need is a little more time

I attached the Main Pic from the Start of Thread  the Spark plug coils are tesla coils they collapse and
output a cold voltage from centres


NEVER STOP
https://www.hot-rod-usa.com/copy-of-h2-training-guide