steve,
these are good questions and a good way of uniting the simpleest view of whats going on..
opposite electrical voltage = not the same electrical voltage or potential difference
Example: +12V opposite=-12V
But only against a common electrode or ground, so to speak.
Sequential mode: = shifting between one and another. In this case: first you pulse +12V and then -12V against a common ground.
So how in practice? Use 3 plates, or 3 tubes. The electrode in the middle should be the common.
What would be the effect of such a setup on water? Well, in my theory, you still have current running, so it stays electrolysis.
If sequential mode means that both the +12V and -12V are powerd on and off with help of a timer, then what do we get?
Do we not have 24V across the outer plates? Still current running? Still electrolysis?
there are only 2 tubes in stans set up and it would be complicating to jump to 3 at the moment but it does sound interesting..
sequential mode= shifting between one another.. i like that thought but i think it is a little more complicated then 1,2,1,2,1,2 (1=pos and 2=neg shift) i think its 1,2,3,1,2,3,1,2,3 (1= pos, 2= both, and 3= neg) since that sequence starts on one and end on three then repeats, it keeps sending a unipolar pulse.. think of each step... step one positve on= pull on electrons push on proton... step 2 both= stability pulse to the protons? step 3 negative on= a deflection of electron and pull on the proton.. its either 1,2,1,2,1,2 or the 1,2,3,1,2,3
.
i think it may be the 1,2,3,1,2,3,1,2,3 becasue the alternator could use its 3 seperate phases to create that effect.. like phase one you would leave the negative choke disconected from the cell, phase 2 both chokes conected, and 3 just the neg conected.. the alternator is geometricaly configured to have 120degee out peaks.. so by coneecting it like that you can hit 1,2,3,1,2,3,1,2,3..
there is no current because of the transformer design.. it is a transformer
if its not them then it could as well be both,both,both,both.. that sounds way simple to replicate with vic 6-1, or it may need 3 to do the job and have their primarys hit in sync...
the key to restricting current is the transformer.. it does 2 jobs capacitor and step up in voltage.. the slots between the pancakes is where the charge is being held, not in the water... when it is charging up you are for one using a low signal to help in not creating amps.. he relys on step up to get it from the low input (leverage) since the chokes are the same length and are right next to each other, when the charge is building the electrons dont leave the core, they are just being manifested into the negative side of the secondary.. opposite potential build on the same core (+ and - choke) will stay on the choke as long as they build in sync... when they separate they have a magntic attraction to each other while there separating on the core.. like a north and south pole sitting next to each other they are pulling on each other.. them pulling on the core in balance makes it more work for the electrons to cross the water so now you create the skin effect on the + and - ... so buy chargeing up, then gating the charge back to ground you are allowing that skinn effect to produce a oscillation in the cell... like a speaker hitting air, but its voltage hitting water.
