Author Topic: scale sized mini tube single test cell. real handy.  (Read 1496 times)

0 Members and 1 Guest are viewing this topic.

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 342
scale sized mini tube single test cell. real handy.
« on: April 01, 2008, 01:23:44 am »

I found this small cell to be very handy and quite impressive.
The gap is .024" which means its perfect for a short tube electrode and it does work very well.
I'm going to make another one the same size just with little differences like a tune slot on the top and a shorter outer tube.
(http://i75.photobucket.com/albums/i283/carbednotch/DSC02353.jpg)

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 342
Re: scale sized mini tube single test cell. real handy.
« Reply #1 on: April 02, 2008, 02:33:04 am »

This video is of the modified cell in action. I modified it by doing 2 notches at the top, plus a notch on the inside tube and also it is offset of the outer tube on the top and bottom. Keep in mind where I weld the wire, on the complete opposite sides to get a full "contact patch".
As far as performace difference I did notice the modified tube did expell more solid bubbles vs mist of the standard design.   
The purpose of the modifications was to encourage waterflow in certain directions and to increase its velocity.

(http://i75.photobucket.com/albums/i283/carbednotch/DSC02362.jpg)
(http://i75.photobucket.com/albums/i283/carbednotch/DSC02368.jpg)