Engines On Water > How to run your car on hydrogen or water

Timing

(1/2) > >>

JimV:
Hey guy's  I'm new to this site,  very intrested in hho.  My background is in performance, race and marine engines.  My question is has anyone changed  cam/valve timing to work with hydrogen?  Im wondering if the valve overlap could be decreased to enhance power output.  Most engines I've seen running on hho don't have any load on them.  Ideling or higher rpm with no load.

I'm working on a 2.5 hp  single cylinder engine that I would like to convert over to hho.  I welded and reshaped the combustion chamber and moved the spark plug location for what I think would be optimal.  The next step is to change the cam timing.  Any thoughts ?

Bubz:
Yes, you can change the timing to just after top dead center to accommodate the burn rate of HHO. Two problems arise... The HHO is more of a percussionary combustion than an incindiary like gasoline. Like you have seen before, it is relatively simple to run a motor on HHO until you put a load on it or try to throttle it. HHO has a small combustion window compared to gasoline making it difficult to keep the proper air/fuel mix ratio. HHO needs to be a 2:1 ratio or it won't combust. The other problem is the low torque which can be remedied with water injection much like they already do in race and performance vehicles. Address these issues and you may have a winner! Good luck!

Bubz

Donaldwfc:
Welcome!

Changing the timing is not required if you change the burn rate of the Hydrogen. This is done by recycling exhaust gasses (key point: non-combustible gases, which exhaust gases are indeed) back into the fuel mixture. This will slow down and modulate the burn rate and temperature. You can match the burning characteristics of diesel, gasoline, propane, or even leaves and paper with this method. Therefore it is not required to change the configuration of any internal combustion engine.

This information is from Stanley Meyer's Documentation and Videos, which are all available on this forum.

Bubz:
LOL! Your stealing my thunder Donald!  ;)

But, yes, Donald said what I was gonna eventually get to.

JimV:
 Most engine's  intake valve opens before top dead center.  The exhaust valve opens well before bottom dead center.  There is a period of time (overlap) when both valves are open.  My thoughts are to shoten the duration on the cam and take advantage of a more complete burn.  Also I would expect the engine make more torque at a lower rpm and would not need to rpm as high.  You would think there would be a less chance of a backfire as well. 

I'm sure  mr. Meyers had a reason for using an aircooled engine, can anyone help me understand  if there was a reason other than cost?

Navigation

[0] Message Index

[#] Next page

Go to full version