Hi I have been going over a lot of old research that I did and the group that I was with, also some guy Russ has also uncovered somethings of importance, and he meet with some one that actually went an saw Myer be for he ministerially died. Then also some of the mystery around the dune buggy seems that it was not all that was shown, yes it was technically running on water. However the whole system also generated electrical power and some form of heat. What some of you see is only some of the whole system not all of it.
He was a cleaver man and done separate patents for each part but I believe and I am not the only one you have to put the whole puzzle together.
There is a resonant part played in the system, the group of rising pulse all together then a short break, that is the negative side cut off by the diode that is a pump up circuit.
The frequency is important, but not the way that you may normally think.
The L/R of the coil T plays a good part in this, generated circulating currents in a resonate circuit can be very high, and with the step up transformer to around, 1500V is also a key.
So in the circuit it states that the wire used was resistance wire in all of the coils.
Why? He generated 1500VAC the diode will halve that to 750V have wave peek when it finally gets there. If you wound the coils in normal winding copper wire, then the DC resistance would be very low in the region of 0.01to 0.0001 so using the L/R technically you could generate thousands of AMPS. That is if the frequency was very low at resonance to give the current rise time to reach 5time T. High Frequency means that it has buckles chance of getting even to one T, 63%of the max current for a coil. Example at resonance XL=XC so all that in in the circuit is the DC resistance, do the sum 750/0.01 = 75,000AMPS! And more 750/0.001 750,000. Now you can may be see why Stan used resistance wire to limit the current at resonance, even then the current that may be there would still in the coil at one T may still not reach the max either. So now we have a circuit basically that is generating high voltage with stuff all current. To me even then in tap water or worse distilled water or deionized water it has all the minerals removed. You still will not break it down as with electrolysis. There is another possible way around the sonar frequencies, 1Ghz is one range,
Sport fishing sonar 50, 120, 200, 455 kHz . The sonar transducer was originally directly touching the water, as then they had tremendous amount of power pushed into them. the problem was that the water all around the Transducer got hot just like a microwave does to your food. What happened with the concentration of the power in one spot water split, the hydrogen and oxygen then burnt in the water pocket around the transducer and blew it up. Now they are not is direct contact with the water. So what does that tell you Stan seems to be doing something similar? Or there is fine arcing between the plates or tubes, this would disassociate the water as an arc is above 3,000C
Sorry to rattle on but I hope you get something from it and re-look at you thinking.
Stan what not telling the whole story publically.
