Ionizationx: a clean environment is a human right!

Electrolysis => Fuel Cells => Tube Cells => Topic started by: Fiditti on July 17, 2008, 23:33:24 pm

Title: Expedient Way To Make Connections to Anode & Cathode of Tube Sets Query
Post by: Login to see usernames on July 17, 2008, 23:33:24 pm
I'm looking for an expedient way to make my electrical connections to the iinner and outer cylinders of my tube sets.  I don't have a tig welder, so in lieu of welding my leads onto the tubes, I need to drill and tap the inner and outer tubes.   I'm not exactly sure what design format I want to use.  I do want my tube sets to be even at the top for the time being.  So, I could have my inner tube projecting below my outer tube at the bottom of the tube sets.  Does anyone have a good tried and proven method they'd be willing to share.  Pics would be helpful.

Also, the last time I tried to run multiple tube sets I had a problem with not enough voltage to each individual tube set.  Does anyone have a design remedy for this they'd be willing to share with me. 

Thanks in advance!!
Title: Re: Expedient Way To Make Connections to Anode & Cathode of Tube Sets Query
Post by: Login to see usernames on July 17, 2008, 23:49:17 pm
go have a look here:
http://www.ionizationx.com/index.php/board,10.0.html

br
steve
Title: Re: Expedient Way To Make Connections to Anode & Cathode of Tube Sets Query
Post by: Login to see usernames on July 18, 2008, 00:21:49 am
Thanks Steve.