Stanley Meyer > Stan Meyers system 2
VIC pictures and Don's VIC notes..
Steve:
--- Quote from: R.Walker on July 27, 2014, 19:47:37 pm ---Here is something I'll share with everyone. Work toward this. It's only pulling .02 - .01ma at 14 volts from the power supply to get this voltage.
--- End quote ---
nice data....
thanks for sharing
impressive from such a low power..
Steve:
Stans core of the VIC dimensions:
Single u core = 0,27cm thick by 6,25cm wide by 6,92cm high by 1,07cm diam.....
2 u cores make 1 set for the VIC
Material: probably ferrite.
permeability +- 2,500
R.Walker:
Got one more shot, after tuning my coils a little more today, I got the full potential out of my VIC. Been running now fro over an hour now and everything is still running cold coils, transistors, ect. I think I will quit while I'm ahead. LOL
Steve:
--- Quote from: R.Walker on July 27, 2014, 23:11:39 pm ---Got one more shot, after tuning my coils a little more today, I got the full potential out of my VIC. Been running now fro over an hour now and everything is still running cold coils, transistors, ect. I think I will quit while I'm ahead. LOL
--- End quote ---
Ron,
What kind of core are you using?
Can i buy it somewhere?
Steve
R.Walker:
Sure can, http://www.aliexpress.com/snapshot/231356182.html
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version