This epg was built by stan for stan to educate himself. He used Rs232's and a monitoring program, along with the circuit located Under the EPG as a Twisted ring counter with the Twisted ring frequency Tuner just to the left as the round black knob. At the end of each coil is Large magnetic coils for magnetizing the gas. He was sending the magnetic gas from one end of the Loop to the other, Playing with it and Monitoring the coils behavior threw the Rs232.
The question is,, What Software was he using?
How did he know about the software?
What caused him to add a laser later? How did he learn what a magnetic Pump was rather than one with moving parts.
Is this all you would like to share? Some of the photos are Bleeped out
