Author Topic: Phase-Locked Loop Project  (Read 6215 times)

0 Members and 2 Guests are viewing this topic.

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 457
Re: Phase-Locked Loop Project
« Reply #8 on: July 19, 2010, 22:06:31 pm »
Yeah wheres the parrallel resistor , put something like 20-200 k
more like 10 ohms and i'm sure this will change the effect  ???

Offline Login to see usernames

  • Moderator
  • Sr. member
  • ***
  • Posts: 460
    • Global Kast : Water Fuel Cell Research
Re: Phase-Locked Loop Project
« Reply #9 on: July 19, 2010, 22:10:42 pm »
yea a 10 ohm resistor changes it back to a basic sine wave.

Offline Login to see usernames

  • 50+
  • *
  • Posts: 68
Re: Phase-Locked Loop Project
« Reply #10 on: July 19, 2010, 23:31:38 pm »
I did the follower haithar .

Take 2 stainless spoons , take my multimeter .

Take tap water , add a bunch is salt , shake water , insert spoon and I was still getting 10+ k ohms

Offline Login to see usernames

  • Moderator
  • Sr. member
  • ***
  • Posts: 460
    • Global Kast : Water Fuel Cell Research
Re: Phase-Locked Loop Project
« Reply #11 on: July 20, 2010, 05:36:30 am »
I'm also working on another circuit that will Auto-Tune to the resonant frequency of it's load.  So far I'm getting good results in my simulation program.  Here's a screen shot of one output from one setup, as you can see it also has the "Ringing" effect.

(http://www.globalkast.com/images/tonywoodside/Auto-Tuning_Resonance_output.bmp)

Online Login to see usernames

  • Administrator
  • Hero member
  • ****
  • Posts: 4441
    • water structure and science
Re: Phase-Locked Loop Project
« Reply #12 on: July 20, 2010, 09:53:27 am »
Looking very good, guys!
 
We have many options to get resonance with like 1khz. If we size the cap bigger and the coil smaller or vica versa.
I have a question: Stan said that the L must be higher then C. Why?
 
Steve

Offline Login to see usernames

  • Sr. member
  • ***
  • Posts: 457
Re: Phase-Locked Loop Project
« Reply #13 on: July 20, 2010, 13:19:26 pm »
I did the follower haithar .

Take 2 stainless spoons , take my multimeter .

Take tap water , add a bunch is salt , shake water , insert spoon and I was still getting 10+ k ohms
yes with a multimeter. but try a 12V battery connected to an ampmeter and then to the spoons. after a few seconds the current will rise heavily.
my tube cell was in the mega ohm range when measuring but pulled an amp easily at 12V (tap water).

Offline Login to see usernames

  • Global Moderator
  • Hero member
  • ****
  • Posts: 3607
Re: Phase-Locked Loop Project
« Reply #14 on: July 20, 2010, 15:36:28 pm »
dankie


You got that reading because the multimeter don't test over 1v so water still behave as a capacitor.


Regards