New interpretation new topic

[Login to see usernames]

Hello my dear friends

I found today some new way of  interpreting the electron extraction grid it may be of some help to lead us to discover how to make Stan secretes come up...

I was thinking about the water cell as being the source of electrons and think about who could be the sync for them to allow power to be generated than an old idea came across

We have a certain important characteristics we must not forget

Gas is generated

The car engine works as a gas pump

A gas can be ionized

Hv D.C. Is involved

Low voltage high current is involved

Power is generated

Meyer says that the gas could be neutralized passing thru grounded tube

So my thoughts are

The low voltage generates the gas

The gas bubble out

The high voltage makes the bubbles loose electrons that will sit on water

The ionized gas will be repelled from the water bath and run thru plastic tube

At this point the gas will be at a higher potential than it were when it was a bubble

So now the gas enter the eec working as an electron sink to extract electrons that remained on water generating power thru a external circuit !

[Login to see usernames]

is HV not dangerous with HHO?

[Login to see usernames]

Probably yes but we need to figure how to make it safer.... maybe with lot of air being bubled together with the buo it become safer

[Login to see usernames]

To be more clear the whole idea is to use the water cell passing thru it a certain amps to generate gas but hold the water at high voltage potential this will allow ions to be formed as the bubbles get out of the water, the bubbler can have a specific geometry to enhance the electric field at the bubble formation....

The ions are driven by the engine air pumping upwards getting sway from the high voltage potential zone as they have same polarity
Here the system present a discontinuity where the ions go away in a hydraulic system but they can give their charge out as soon as it pass thru a metallic tube! During this stage another gas can be formed depending on the conditions present. Because the ions can react with other gases present specially in the presence of a catalyst.

The electron extraction works like charging and discharging a capacitor is required to discharge to charge again!

[Login to see usernames]

the high voltage ckt is going to have the ionization current ...I'm thinking that the ecc is going to reduce this because the electrons will have other way to go ! Basically the idea is that the ions will get pumped in energy by collisions with a metal target energizing the allowing to be further stripped off electrons ... like a chain every step will have its own ckt

[Login to see usernames]

Multipacting for exciting atoms to reach higher ionization leves

[Login to see usernames]

When multipacting is achieved the voltage will peak at the input coils as the multipacting creates a short ckt like effect drawing power for the resonance

[Login to see usernames]

I think we're starting to understand how it works.  Electrons are removed on impact with the outer tube, due to its positive potential. When we add in ionization electrons which are produced by collisions between the molecules themselves, these electrons are removed by the charge pump extraction ring.