Resonance WFC measurements

[Hidden]

I'm talking about the Resonance WFC cell driver circuit, not a 8XA coil.

To make it more clearer see fig below.

Br,
Webmug

[Hidden]

gotcha, thanks for circuit diagram, I may try it anyway into my 3 inch, 1/2 mm gap tubes....  after my bifilar toroid

[Hidden]

@Dave, All,

This is what I measured on a 10kV 1nf capacitor.
Could be the above 0V voltage that brings up the "above ground level".
http://www.ionizationx.com/index.php/topic,1305.msg22180.html#msg22180
http://www.ionizationx.com/index.php/topic,1305.msg22161.html#msg22161

PULSE TRANSFORMER The typical pulse transformer operates in an “unipolar” mode ( flux density may meet but does not cross zero ).
http://www.ionizationx.com/index.php/topic,1934.msg20298.html#msg20298

Br,
Webmug

[Hidden]

looks pretty good to me. So 500 volts or so is the highest you've gotten?
Anything special you did to get your singnal inverted like that?

[Hidden]

looks pretty good to me. So 500 volts or so is the highest you've gotten?
Anything special you did to get your singnal inverted like that?

My chokes are not tuned, the voltage amplitudes are not equal but have opposite voltages when I vary the pulse frequency. I can not tune it with the pulse and gate signals. Chokes are not matched!
I tested this on a 10kV 1nf HV capacitor, when I use my wfc this waveform is not there. So the cell specs are very important to minimize leakage, I think...

Br,
Webmug