tube cell 1.0

[Hidden]

my tube cell is pretty simple. The ouside of the outer tube is powder coated, the inside of the inside tubes are capped. The cell doesn't have spacers between the tubes; I simple used some 3/4" pvc male addapter and drilled some holes in it to let water in and gasses out. I can get high voltage across the cell whens its not underwater(300volts) The next thing to try is to apply high voltage when the cell is under water. I'll post back with the results 

[Hidden]

Hi Dave,


Looks good!
So, you hit it with the ignition coils?

Steve

[Hidden]

hello steve
yes i've been trying an modified ignition coil with little success. I haven't been able to get more then a few volts across the cell when it is in water. 

[Hidden]

hello steve
yes i've been trying an modified ignition coil with little success. I haven't been able to get more then a few volts across the cell when it is in water.

Hi Dave,

Just have a look on how Tony is getting hv across his tubes....

Steve

[Hidden]

thanks Steve, i havent had time to read through all the info on this forum yet. Tonys 8XA replication looks promising, i think ill try to build my own in a few weeks when i'm home from school again.