Author Topic: New resonant cavity  (Read 1796 times)

0 Members and 1 Guest are viewing this topic.

Offline Hidden

  • Moderator
  • 50+
  • *
  • Posts: 75
New resonant cavity
« on: September 30, 2010, 03:45:24 am »
Here are a couple of my new cells


Offline Hidden

  • Administrator
  • Hero member
  • ****
  • Posts: 3752
    • water structure and science
Re: New resonant cavity
« Reply #1 on: September 30, 2010, 15:01:09 pm »
Fantastic setup, Hardkrome!!

Any idea on your electronics and coils?

Steve

Offline Hidden

  • Hero member
  • ****
  • Posts: 986
Re: New resonant cavity
« Reply #2 on: September 30, 2010, 16:52:41 pm »
Nice work!


What is the hole on the side of the tube for? you can barely see it in the picture of the cell on top of the car.
How much pressure can that hold before the press-fit seal is broken?

Offline Hidden

  • Moderator
  • 50+
  • *
  • Posts: 75
Re: New resonant cavity
« Reply #3 on: October 01, 2010, 01:03:59 am »
Without the clamp on the top piece not much maybe a pound. I built the relief valve and set it for 10psi.
 
I have many transformers and coils. I have made just about every circuit out there, they dont work right, so I designed my own. I kept redesigning it and rebuilding it, going back and forth thru the whole deal.
 
 
 The top cell is an adjustable taper cavity, the outlet is on the side not the top. No stone is left unturned.