New project : replicating the Stephen Meyers driver

[Hidden]

Ok well , Its gonna be ab with some biasing , wich sucks , means 20% more wasted watts .


I would of liked a super feedback class b yet ab , Ill try it and see if it works anyways .

6 of these will have to be constructed , 6 big *  heatsinks with 12x transistors . Shouldnt cost more than 70$ lol

1 per phase , 6 phases in all . I mean 3 phases x 2 .

Anyways this thing is gonna be just a joy to work with if everything turns out right .

Cant wait till spring break and experiment Meyers style .

Im gonna be really really busy at school this semester .

This thing can be used as an hvdc power supply as well , always wanted one of those , but the main oscilator will have to be changed for a goodl old cd4047 and the filter will have to be tuned , because the linear oscillator cant go low frequencies .

For those who wanna do this I will tell you how , just change a few resistors and caps and solder a ghetto rigged oscillator.

[Hidden]

Yes , this is the final version , after  100's of  hours of grueling work . On this board lies perfection . On this board lies the future of HHO research . I will bankrupt Hydrogen garage once and for all . in case it wasnt already bankrupt .

A harmonics oscillator with gate synched EEC  , with 2 mosfet and room for 2 x 30 watt heatsink

A 200-25000 hz dual 3 phase oscillator pure sine oscillator  , pre-amp includes 6 x amps 50 p-p volts 300ma each with room for 6 x 20 watt smt heatsinks . pnp npn /w heatsink not included .

A 4 quadrant synched amplitude modulator with independant carrier and modulation amplitude and frequency , Puharich style . Uses a single driver as mentionned above .

[Hidden]

Tell me if you see any mistakes haha !

A mistake means wasted bucks , this aint so cheap and small board like Jolt . Frikkin 3 minimum ...

The op amps wont get here till at least a month anyways .

Every new scan costs the exact same , even if you just added a single drill hole . This is how they make their money .

[Hidden]

This is fine - you could use simply - an IR2133 - 3phase chip - to do this - and then you need a big toroid - with three separate transformer windings - each driven by an output from a phase of the IR2133 chip...
You also need to make sure that the "charging chokes" are exactly wound to match your cell...(one VIC circuit per tube set)-and that the "alternator winding" - secondary of the toroid windings... matches the whole VIC circuit - because when the cell and charging chokes and winding - go into parallel resonance - that the secondary winding does not interfere with the parallel resonance....(read between the lines patent 4936961). Also select the blocking diode very carefully - so that secondary breakdown point occurs at the right voltage - allowing - proper - parallel resonance to occur - for at least the last 3rd to 5th pulse of the oscillator...hmmm.. This allows you to get proper extremely high voltages on the cell - before and after the oscillator stops - step charging the cell...
regards
cardac